YAMAHA feeder Calibrator
This product is used to confirm the tape feeders (feeder) spaced locations (adsorption sites) and adjusted with special equipment. This product uses a CCD camera and a high-powered magnifying glass, observe the feeding through the display case, thimble and down movement and leverage wear, reduce rack bad butt caused problems, to improve the placement yields a very good help.
Product Features:
A simple, compact and simple appearance.
2 microcomputer control, automatically adjust the feeding speed can do, sub-manual and automatic feeding mode.
3 gas or Japan SMC solenoid valve Koganei, ensure that the control part of life.
4 X, Y, H transmission in three directions are used precision screw drive, guide mechanism in each direction using two precision imported linear bearings and precision guide columns, to ensure reliable transmission and guiding precision.
5 CCD camera plus 50mm magnifying glass with LED lighting to make the picture clearer.
6 ways to combat pneumatic lever, simulated machine action.
7 observed dynamic walking gear material situation.
8 feet with a standard calibration to adjust the suction center.
9 whole body chrome, beautiful and durable.
|
Your Location: 